Skip to main content

IP Ratings

An IP rating must begin with 5 for partial dust protection or 6 for complete dust protection. The IP rating is two digits, with the first and second digit defined as follows: 
First Digit (intrusion protection)

0. (or X - see section below): No special protection. Not rated (or no rating supplied) for protection against ingress of this type. 
1. Protection from a large part of the body such as a hand (but no protection from deliberate access); from solid objects greater than 50mm in diameter. 
2. Protection against fingers or other object not greater than 80mm in length and 12mm in diameter (accidental finger contact). 
3. Protection from entry by tools, wires etc, with a diameter of 2.5 mm or more. 
4. Protection against solid objects larger than 1mm (wires, nails, screws, larger insects and other potentially invasive small objects such as tools/small etc). 
5. Partial protection against dust that may harm equipment. 
6. Totally dust tight. Full protection against dust and other particulates, including a vacuum seal, tested against continuous airflow. 

Second Digit (moisture protection)

0. (or X - see section below): No protection. 
1. Protection against vertically falling droplets, such as condensation. ensuring that no damage or interrupted functioning of components will be incurred when an item is upright. 
2. Protection against water droplets deflected up to 15° from vertical 
3. Protected against spray up to 60° from vertical. 
4. Protected against water splashes from all directions. Tested for a minimum of 10 minutes with an oscillating spray (limited ingress permitted with no harmful effects). 
5. Protection against low-pressure jets (6.3 mm) of directed water from any angle (limited ingress permitted with no harmful effects). 
6. Protection against direct high pressure jets. 
7. Protection against full immersion for up to 30 minutes at depths between 15 cm and 1 metre (limited ingress permitted with no harmful effects). 
8. Protection against extended immersion under higher pressure (i.e. greater depths). Precise parameters of this test will be set and advertised by the manufacturer and may include additional factors such as temperature fluctuations and flow rates, depending on equipment type. 
9. (K): Protection against high-pressure, high-temperature jet sprays, wash-downs or steam-cleaning procedures - this rating is most often seen in specific road vehicle applications (standard ISO 20653:2013 Road Vehicles - Degrees of protection). 



Source - CWNP (www.cwnp.com)

Popular posts from this blog

Availability of 5 GHz WLAN Channels in India under unlicensed band

Availability of 5 GHz WLAN Channels in India under unlicensed band  In India, Wireless Planning and Coordination Wing of Department of Telecom, under Ministry of Communication takes care of licensing of radio frequencies.  In the latest National Frequency allocation plan 2018 (https://dot.gov.in/sites/default/files/NFAP%202018.pdf), Government of India (GoI), exempted the licensing requirements of the following radio frequency ranges for wireless usage and a gazette notification has also published for this (https://dot.gov.in/sites/default/files/License%20Exemption%20in%205%20GHz%20G_S_R_1048%28E%29%20dated%2022nd%20October%2C%202018_0.pdf)  -- 1.  5150-5250 2. 5250-5350 3. 5470-5725 4. 5725-5875 References

Why we have IPv6 after IPv4..... Where is IPv5 ?

IP or Internet Protocol, is the primary network protocol used on the Internet, introduced by Vint Cerf and Bob Kahn in 1974. IP version 0 to 3 was introduced and used between 1974 and 1979. After changes and refinements in initial IP protocol, version 4 was introduced in 1981, commonly known as IPv4, described in RFC 791 , which become the backbone of Whole Internet in no time. (IPv4 is know as v4 because it is the fourth version of IP not because it has 4 octets, which is a common myth). TCP/IP Protocol was designed as a part of project ARPANET, whose aim was to interconnect various universities and research institutes of USA. But with the dot com boom, TCP/IP grows like anything and its become a victim of its own success. In Early 90's, expert realized that we will exhaust the whole IPv4 number very soon and there is a need for a new protocol, which should be enough in size to serve the internet community for at least 30-40 years. This lead to new version of Internet Protoco...

Shouldn't India have a Root Server ???

A Root name server is a name server for DNS root zone. Every new DNS query resolved by our local resolver first goes to Root Name Server and then root name server directs it to required domain server. This means that if in any case, root name servers goes down, then whole internet goes down (don't worry this cannot be done so easily as most of root name servers are running on Anycast and located all over the world). Recently, an anonymous group posted, to target these 13 root name severs and to bring them down by DDOS attack on 31st March 2011, to protest against SOPA and PIPA. But as expected, they didn't succeed. The last time someone seriously tried to take out the root servers was about 4 or 5 years ago and they managed to take down six out of thirteen servers. I am not saying that it could not be done but it would be tough. Every root name server is operated by different organization (except 'A' and 'J' which are operated by VeriSign) but they all po...